Crane hook part maintenance

 (1)Dismount all the Crane hook part head, shaft, beam, pulley block, bearings, check the condition, clean and lubricate if necessary.

(2)Check the wear condition of the dangerous cross section.

(3)Test the Crane hook part.

(4)Check the condition of Crane hook part plate.

  • Crack is not allowed on the Crane hook part, beam and pulley block. The screw cannot be loosened. The bearing should be in good condition. Rotate the pulley, if find out the cutter mark or crack on the tool escape, please change it.
  • If the wear of the dangerous cross section is more than 10% compare to the original height, please change it.
  • After the repairing, testing and checking is necessary for the Crane hook part. Hanging the 1.25 maltaple weight compare to lifting capacity in 10 minutes, the mouth of Crane hook part should be opened less than 0.25% compare to the original size. After unloading the deformation and crack are not allowed.
  • After riveting for the Crane hook part plate, the gap between the plates should be less than 0.3 mm.

评论

此博客中的热门博文

Manual Chain Hoist Structure

Bridge Crane and Overhead Crane Systems

32 ton electric chain hoist for sale